Kent-Moore DT-52494 | Pinion Bearing Cup Installer
Application: 2019-later Silverado, Sierra with 9.5” and 9.76” Ring Gear Rear AxlesDT-52494 Installs the Pinion Bearing cup on 9.5” and 9.76” Ring Gear Rear Axles. DT-52494 is used with J-8092 Drive Handle and Pilots into the Bearing cup to Install the cup into the Axle Housing.DT-52494 will also back-service all 9.76” Ring Gear Rear Axles from 2014-current, replacing J-45240 due to a Bearing cup update.
Other Kent Moore products
| EN-52442 - Balance Shaft Holding Tool | Click to View |
| EN-52074 - Glow Plug Bore Carbon Remover | Click to View |
| EL-51102-30 - Battery Pack Lifting Eye-Bolts kit, Washers, Nuts | Click to View |
| EL-47955-1 - Mdi 1, Mdi 2 Self-Test Loopback Adapter | Click to View |
| EN-48974-30 - Egr Cooler Tester Adapter Set, 1” | Click to View |
| EN-51151 - Crank Shaft Rear Oil Seal Installer | Click to View |
| DT-47928-2 - Bearing Installer Tool Set – Base | Click to View |
| DT-52017 - Vent Hose Pipe Installer | Click to View |
| EL-50334-6 - Audio System Diagnostic Cd | Click to View |
| J-2222-C - Wheel Bearing Nut Wrench | Click to View |
