Kent-Moore EN-52451 | Fuel Injector Remover
EN-52451 fits into the Retaining slots for the Fuel Injectors on 3.0L Diesel (RPO LM2) Engines and is used with EN-51146-1-3 Sliding Hammer to remove the Injector from the Cylinder head. Once the Retaining Bridge is removed from the Cylinder head, EN-52451 is placed on the Injector Body in place of the Retaining Bridge. EN-51146-1-3 is then attached to EN-52451 and used to remove the Injector. Unapproved methods will damage the Injector or surrounding components.
Other Kent Moore products
| KM-658-1 - Installer, Rear Crank Shaft Seal (1.4L) | Click to View |
| DT-50897 - Installer & Case Extension Bearing | Click to View |
| DT-51983 - Seal Installer, Input Shaft, Case Side | Click to View |
| EN-50723 - Valve Stem Seal Installer | Click to View |
| J-9522-5 - U Joint Bearing Spacer Remover (Use Withj-9522-3) | Click to View |
| KM-869 - Seal Installer | Click to View |
| EL-49903-6 - Onstar -Gen10 Antenna Adapter | Click to View |
| DT-51976 - Fdu Output Seal Installer | Click to View |
| EL-50334-13 - Infotainment Test Cable Splitter (Rse) | Click to View |
| J-29162 - Seal Installer | Click to View |
