Kent-Moore EN-52287-7 | EN-52287 Balancer Holding Adapter-LTA Engine
EN-52287-7 Adapter allows the use of EN-52287 to hold the balancer when removing or Installing the balancer Bolt. Using EN-52287 and EN-52287-7 allows on-vehicle service without having to remove the starter to Install the Flywheel Holder, reducing the time required for the Repair. The LTA balancer does not have a Bolt pattern that allows existing Tools to attach to the balancer. EN-52287-7 engages in the casting voids in the balancer to hold it, while EN-52287 is Locked against the vehicle cradle to allow the Bolt to be removed or Installed.
Other Kent Moore products
| J-43263 - Valve Spring Compressor | Click to View |
| EN-50885 - Remover/Installer High Pressure Pump | Click to View |
| EN-52055 - Engine Support Table Adapter Set | Click to View |
| CH-51450-LEAD - Diagnostic Lead kit With Probes | Click to View |
| J-8612-B - Rear Pinion Bearing Remover | Click to View |
| CH-47976-503 - Sidi Harness kit | Click to View |
| J-47158 - Clutch Plate Selector | Click to View |
| J-46239 - Second Coast Clutch Piston Protector Set | Click to View |
| J-42854 - Trim Height Gage | Click to View |
| J-43890 - T-Harness Adapter | Click to View |
