Application: 2019 Cadillac XT4 with 2.0L-T LSY Engine; 2019 Silverado and Sierra with 2.7L-T L3B EngineEN-52476 Installs in place of the starter and ensures that the Flywheel is in the timed position for timing chain service. It also Locks the Flywheel Ring Gear teeth to allow Flywheel Bolt, balancer Bolt, and Cam Shaft actuator Installation and Torqueing. Once the Body of EN?52476 is Installed in place of the starter, the Flywheel is turned until the Spring-Loaded Lock Pin engages into the timing Hole in the Flywheel.
Once the timing service is completed, the Lock Pin is pulled back and turned ¼ turn to hold it in the retracted position. At this point, the Locking tooth can be engaged into the Ring Gear and tightened to hold the Ring Gear for Torqueing the required fastener(s). There are two Ends on the Locking tooth, to fit multiple Engines and future applications.
IMPORTANT: The timing Pin MUST be retracted before Torqueing any fasteners. Torqueing fasteners with the timing Pin engaged in the Flywheel timing Hole will damage the timing Pin on EN-52476.
Other Kent Moore products
| J-45126 - Snap Ring Pliers | Click to View |
| J-44871 - Hub Seal Installer | Click to View |
| J-45232 - Adjuster Bearing Replacer (Left Side) | Click to View |
| DT-48009-3 - Gauge, Depth | Click to View |
| DT-50712 - Bearing Cup Replacer | Click to View |
| J-38125-SIR - Sir/Srs Terminal Repair Supplement kit | Click to View |
| CH-47960-10 - Digital Angle Gauge Adapter | Click to View |
| CH-47976-504 - Sidi Harness kit | Click to View |
| EL-51763 - Battery Section Covers | Click to View |
| EN-47630 - Holder Crank Shaft | Click to View |
