During Ring and Pinion or Bearing service, selecting the correct Pinion shim is critical to the operation and service life of the Axle. DT-51629 allows technicians to measure the initial Pinion Bearing shim required on Dana 190 mm, 200 mm, and 220 mm Axles. These Axles place the Pinion shim under the Inner Pinion Bearing cup, instead of between the Inner Bearing and the Pinion. To deTermine the required shim, the Gauge Plate for the Axle being serviced is Installed into the Inner Bearing cup Bore along with the Inner Bearing cup and Cone, and the arbor and Side Bearing discs are Installed in place of the Differential case. J-8001 Dial Indicator is mounted and zeroed on the arbor when the plunger is contacing the Gauge Plate. The plunger is then moved off the Gauge Plate, and the Dial Indicator reads the required shim.
Other Kent Moore products
| J-47275 - 80 Pin Breakout Box Adapter | Click to View |
| DT-51884 - Lift Assist, Motor A & B | Click to View |
| KM-553-A - Remover | Click to View |
| J-45107 - Tone Ring Remover & Installer | Click to View |
| J-9519-E - Lower Ball Joint Remover And Installer | Click to View |
| J-45057-A - Engine Support Bar | Click to View |
| J-38125-615 - Box, Plastic (Single Compartm) | Click to View |
| J-44644 - Front Crank Shaft Seal Remover | Click to View |
| BO-51843 - Window Removal Tool kit | Click to View |
| CH-45400-B - Branick Strut Spring Compressor | Click to View |
